Help keep the community database accurate and up-to-date
← Back to labelsSubmissions are reviewed before going live. No account required.
What are you submitting?
Select the filament to correct — all fields will pre-fill.
1 · Filament Identity
Name is required.
Family is required.
Direct link to the Bambu Lab Technical Data Sheet PDF.
Must be a valid URL (should end in .pdf).
Product page on the Bambu Lab store (bambulab.com or bambu3d.com).
Must be a valid Bambu Lab store URL.
2 · Print Settings
–°C
Min and max required (100–400 °C, min < max).
–°C (optional)
≤mm/s
Max speed required (1–1000 mm/s).
–%
Min and max required (0–100%, min ≤ max).
3 · Storage & Drying
<% RH
Max humidity required (0–100%).
Required.
Required.
Required.
hrs @°C
Leave blank if not applicable.
hrs @–°C
Leave blank if not applicable.
4 · Hardware Requirements
Check all compatible sizes. Mark one as Recommended.
At least one nozzle size required.
Required.
Check all compatible plates and enter bed temperature range.
At least one build plate required.
Liquid Glue and Glue Stick can both be selected. "None" is mutually exclusive.
At least one option required.
5 · Post-Processing
What is annealing? Slowly heating a finished print (e.g. in an oven), then letting it cool. Reduces internal stress, improves strength and heat resistance. Only relevant for a few materials (PLA, PET, PA). Most materials: leave unchecked.
–hrs @–°C
6 · Mechanical Properties
From TDS — check N/A if the property doesn't apply to this material
kJ/m²
kJ/m²
MPa
MPa
%
°C
°C
°C
°C
7 · Colours
At least one required for new filaments
At least one colour with a name is required.
8 · About You optional
Optional — to be notified when your submission goes live. Never shared publicly.
Your submission creates a pull request. Once reviewed and approved, the site updates automatically. No account required.
Live Preview
Fill in the form to see a live preview.
Updates as you type. Identical to the printed card.